1. Click "Start Menu" then select "Run" 2. Type "ncpa.cpl" then click "ok" 3. Right Click "LAN or High-Speed Internet" then click "Properties"  4. Select "Internet Protocol (TCP/IP)" then click "Properties"   5. Select "Use the following IP address". Type in...

  1. If all computers can't connect, then we need to remove the router from the network, temporarily.   2. Connect the DSL Modem directly to your PC's Ethernet connection. (See Figure for details). Note: you will need to reset the modem and the PC, after you have...

1. Turn off your computer. When it has shut down completely, proceed to the next step. 2. If you have a router, remove the power cable. Wait thirty seconds. 3. Plug your router back in. 4. Turn your computer back on. When it is completely powered up, you should have your...

1. Turn off your computer. When it has shut down completely, proceed to the next step. 2. Next, remove the "power cable" from the modem (either at the wall or at the modem). Wait thirty seconds. 3. Plug your modem back in. 4. Turn your computer back on. When it is...

1. Open any "web browser" and type your default gateway (ex: 192.168.0.1) in the "address bar". If router has been reset default login is: admin/admin 2. Click the "Internet" link. 3. Click the "Static IP Link". 4. Type in the "IP address, IP Subnet Mask, Default...